This chapter describes WAN Restoral System (WRS) messages. For information on message content and how to use the message, refer to the Introduction.
| WRS.001 |
Level: C-INFO
Short Syntax: WRS.001 Primary net network ID switching to secondary net network ID
Long Syntax: WRS.001 Primary interface number network ID switching to secondary interface number network ID
Description: The primary interface is being restored through the secondary circuit.
| WRS.002 |
Level: C-INFO
Short Syntax: WRS.002 Primary net network ID restored on secondary net network ID
Long Syntax: WRS.002 Primary interface number network ID restored on secondary interface number network ID
Description: The primary interface has been restored through the secondary circuit.
| WRS.004 |
Level: C-INFO
Short Syntax: WRS.004 Secondary net network ID switching back to primary net network ID
Long Syntax: WRS.004 Secondary interface number network ID switching back to primary interface number network ID
Description: The secondary interface is being restored through a secondary circuit.
| WRS.006 |
Level: C-INFO
Short Syntax: WRS.006 Switch to sec net network ID averted pri net network ID disabled
Long Syntax: WRS.006 Switch to secondary interface number network ID averted primary interface number network ID disabled
Description: The switch to secondary interface has been averted, primary interface is disabled.
| WRS.007 |
Level: C-INFO
Short Syntax: WRS.007 Secondary net network ID failed resort to primary net network ID
Long Syntax: WRS.007 Secondary interface number network ID resorting back to primary interface number network ID
Description: The secondary interface has gone down causing a switch back to the primary circuit.
| WRS.008 |
Level: C-INFO
Short Syntax: WRS.008 Sec net network ID swt to AVL; pri net network ID bck ONL
Long Syntax: WRS.008 Secondary net number network ID switch to AVAILABLE; primary net number network ID back ONLINE
Description: The switch to secondary interface has been aborted, primary still active and on-line.
| WRS.009 |
Level: C-TRACE
Short Syntax: WRS.009 Packet forwarded pri net network ID onto sec net network ID
Long Syntax: WRS.009 Packet forwarded from the primary interface number network ID onto the secondary interface number network ID
Description: A packet has been forwarded from the primary interface onto the secondary interface.
| WRS.010 |
Level: C-TRACE
Short Syntax: WRS.010 Packet received on pri net network ID from sec net network ID
Long Syntax: WRS.010 Packet received on primary interface number network ID from secondary interface number network ID
Description: A packet has been received onto the primary interface from the secondary interface.
| WRS.012 |
Level: C-TRACE
Short Syntax: WRS.012 Unable to forward pri net network ID onto sec net network ID
Long Syntax: WRS.012 Packet forwarded from the primary interface number network ID onto the secondary interface number failed network ID
Description: A packet cannot be forwarded from the primary interface onto the secondary interface.
| WRS.013 |
Level: C-INFO
Short Syntax: WRS.013 Switch to sec net network ID aborted, sec restoral disabled
Long Syntax: WRS.013 Switch to secondary interface number network ID aborted secondary restoral disabled
Description: The switch to secondary interface has been aborted, secondary restoral is disabled.
| WRS.022 |
Level: UE-ERROR
Short Syntax: WRS.022 Protocol initialization on sec ignored, prot = type on nt network ID
Long Syntax: WRS.022 Protocol initialization on secondary ignored, protocol = type on network network ID
Description: Invalid protocol configured on secondary circuit.
Cause: Software configuration out of date, contact customer service.
| WRS.023 |
Level: UE-ERROR
Short Syntax: WRS.023 Sec int disabled, mismatch datalink nt network ID
Long Syntax: WRS.023 Secondary interface disabled, mismatched datalink type network network ID
Description: Mismatched data-link type was configured on secondary interface; data-link type must match primary interface.
| WRS.024 |
Level: C-INFO
Short Syntax: WRS.024 Perform n_up for net network ID
Long Syntax: WRS.024 Perform deferred net-up for interface number network ID
Description: The specified primary interface has been up continuously for the configured stabilization period, so the router posts the deferred net-up notification.
| WRS.025 |
Level: C-INFO
Short Syntax: WRS.025 Reroute pri network ID alt network ID
Long Syntax: WRS.025 Begin rerouting for primary network ID using alternate network ID
Description: The specified primary interface went down (or has not come up within the configured first-stabilization period) so the router brings up the alternate to provide rerouting service.
| WRS.026 |
Level: C-INFO
Short Syntax: WRS.026 End reroute pri network ID alt network ID
Long Syntax: WRS.026 End rerouting for primary network ID using alternate network ID
Description: The specified primary interface no longer requires the rerouting services of the alternate. If no other primary interfaces need the alternate's services, the router restores the alternate to its state before the router brought it up for rerouting.
| WRS.027 |
Level: C-INFO
Short Syntax: WRS.027 Queue deferred n_up for pri network ID
Long Syntax: WRS.027 Queue deferred net-up for interface number network ID
Description: The specified primary interface came up, but the router defers the net-up notification for the configured stabilization period.
| WRS.028 |
Level: C-INFO
Short Syntax: WRS.028 Queue delayed n_up for pri network ID
Long Syntax: WRS.028 Queue delayed net-up for interface number network ID
Description: The specified primary interface came up, but the router delayed the net-up notification until the configured time-of-day revert-back start time. Stabilization period, if configured, has already passed.
| WRS.029 |
Level: C-INFO
Short Syntax: WRS.029 Dial-ofl switch some prots pri network ID alt network ID
Long Syntax: WRS.029 Dial-on-overflow switching some protocols from primary network ID to alternate network ID
Description: The dial-on-overflow add-threshold was exceeded and the defined protocols are being switched to the alternate interface.
| WRS.030 |
Level: C-TRACE
Short Syntax: WRS.030 Dial-ofl traffic pri network ID sp speed add add-count drp drop-count in: in-count out: out-count
Long Syntax: WRS.030 Dial-on-overflow sample traffic primary network ID speed speed add-count add-count drop-count drop-count in-count: in-count out-count: out-count
Description: The dial-on-overflow function is sampling the traffic on the primary link to determine whether the add- or drop-thresholds are exceeded. The configured link speed, the threshold counts for adding or dropping the alternate, and the actual in and out counts during the last interval are reported.
| WRS.031 |
Level: C-INFO
Short Syntax: WRS.031 Dial-ofl not enabled pri network ID wrong dta lnk type
Long Syntax: WRS.031 Dial-on-overflow not enabled primary network ID wrong primary data link type
Description: Dial-on-overflow was configured for a primary link that has a data link type that is invalid for dial-on-overflow.
| WRS.032 |
Level: C-INFO
Short Syntax: WRS.032 Dial-ofl pri network ID alt network ID min alt up time sec sec exprd
Long Syntax: WRS.032 Dial-on-overflow primary network ID alternate network ID minimum alternate up time sec seconds expired
Description: The minimum dial-on overflow alternate up time for the specified primary/alternate pair expired. The dial-on-overflow protocols will be switched back to the primary link.
| WRS.033 |
Level: C-INFO
Short Syntax: WRS.033 WRR alt network ID down, was rerouting for pri network ID
Long Syntax: WRS.033 Wan reroute alternate link network ID has been marked down, was rerouting for primary network ID
Description: The wan-reroute alternate link that was actively rerouting traffic for the specified primary has been marked down.
| Panic wrsimem |
Short Syntax: WAN restoral initialization failed, no memory.
Description: The WAN restoral initialization failed to allocate sufficient memory to complete initialization.
Action: Contact customer service.